Unsolved
This post is more than 5 years old
17 Posts
0
253
January 31st, 2007 17:00
Automatic Failover fails
Hey guy any help would go a long way.
This is a test lap.
I have RepliStore installed on two domain controllers with exchange on each DC. I have an alias setup and it manually fails over just fine. However, If I pull the network cable out of the source server it starts to failover...however it fails. Usually it gives errors about not able to start the mail services.
The domain controller that is the source server holds all the AD rolls and is the schema master. Each DC is a DNS Server. and has both it's own IP and the other DNS Server ip.
Thanks every.
This is a test lap.
I have RepliStore installed on two domain controllers with exchange on each DC. I have an alias setup and it manually fails over just fine. However, If I pull the network cable out of the source server it starts to failover...however it fails. Usually it gives errors about not able to start the mail services.
The domain controller that is the source server holds all the AD rolls and is the schema master. Each DC is a DNS Server. and has both it's own IP and the other DNS Server ip.
Thanks every.
0 events found
No Events found!
dramjass
151 Posts
0
February 21st, 2007 11:00
Demote one box to just an Exchange box and setup the DC on another box.
Where do you see the errors when the Exchange services do not start?
Event Viewer, RepliStor?