Start a Conversation

This post is more than 5 years old


Go to Solution


March 20th, 2014 00:00

vRPA: load balancing and adding target


how is loadbalancing working between a vRPA and the VNX iSCSI targets?

Is it using powerpath or some iSCSI linux multipathing?

And if we want to add some extra iSCSI interfaces on the VNX, is there a procedure or command to let the vRPA's login to this new iSCSI target address?



87 Posts

April 1st, 2014 09:00

we managed to get some extra initiators using boxmgmt.

We had to add the initiator a couple of times and when you add them, just be patience.

It will take some time but at the end the vRPA will register the host on the VNX.

Looks like it's using Round-Robin between the different interfaces.

No Events found!