Reliability paramter in SMARTS

Question

Hi Team,

How can we monitor reliability parameter in smarts.

I am not getting response from the OID

OID of reliability :

locIfReliab 1.3.6.1.4.1.9.2.2.1.1.22

http://www.oidview.com/mibs/9/OLD-CISCO-INTERFACES-MIB.html

3600#show interfaces fastEthernet 0/0

FastEthernet0/0 is up, line protocol is up

Hardware is AmdFE, address is 0001.42b4.fe81 (bia 0001.42b4.fe81)

Description: testme

Internet address is 10.16.99.20/24

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Is there any way or by uploading a mib file ...can we monitor relaibility of interfaces?

or through ITPR if any classes needs to be abstarct for relaibility.

Need this very urgently....

Thanks

Rohit

Rohit_emc2 · Answer

Thanks for the response..

To monitor reliability paramter is one of the essential requirement raised by NOC team.

Do you mean the first we need to upload the mib file and then by dynamic modelling introduce the parameter?

I am waiting for support response too.....

Thanks again for your inputs.....

Rohit_emc2 · Answer

Thanks for the response. We only want to monitor the reliability value for example 255/255 for all interface. It should show under the attribute tab. Thanks

Rohit_emc2 · Answer

Thanks njsf ...

I tried a lot but unable to create a required mdl file for reliability paramter.... It would be really helpful if you could please guide me how to get this code...

Thanks again....

rohit_emc@yahoo.co.in

Smarts

Reliability paramter in SMARTS

Was this post helpful?