We are using SRDF/A.

Can anyone from the forum answer my question?It's urgent.

Thank You.

Bullop, Its running in failedover state that means no replication back to R1(links down and r2 is up).All i need to do is make r1 up and running.

Thanks

Yes,Thats absolutely correct,There are two Non-RDF devices on R2 side which needs to replicate.  

Bullop,Can you please give a step by step procedure for this.Also is there anyone in the forums know a different procedure to do this.

Thanks

Hello Praveen,

I think at this point you should call into the support center for assistance. I would not want to tell you the wrong

thing to do.I wouldn't want to have you do anything that would have you lose any data. Sorry.

Praveen was Support able to assist with this.

From what I have read I believe the cleanest way to have done this is as per below, however as per the last comment I would recommend you consult support before performing any of these actions

1. Do a swap , so this makes the R2 (Target)  the R1 (Source) and the R1 (Source)  the R2 (Target)

2. You can then add your 2 devices at this stage

3. Allow Devices to Synchronize

4. Perform a Failover

5. Do a Swap, returns back to your previous state, except now you have the 2 devices added, and the data from the orignal R2 is now on the original R1

Hi, I already opened a case with emc as a low priority so still in the queue.Anyways what will be the replication mode if we perform a swap operation.

Thanks