Unsolved
This post is more than 5 years old
5 Posts
0
1953
September 27th, 2018 12:00
Platform Events destination IPs do not save
Hello there,
We have Dell OpenManage inside of our Dell PowerEdge servers. One of our problems is that we cannot save destination IPs after we enable Platform Events. It reverts itself back to 0.0.0.0 every single time and this is no matter what browser I try. I've used Chrome, IE, Firefox, and Edge.
No Events found!
Daniel My
12 Elder
•
6.2K Posts
0
September 27th, 2018 15:00
Hello
I've not encountered any issues performing that task. I just tested on one of my servers and it saved. Make sure you are hitting the apply button at the bottom right and waiting a few seconds before exiting the page.
I suggest reviewing the release notes of the version you are using, you can also review the manual. There should be information about compatible browsers. If there are known issues then there should be information about security settings or other changes that may need to be made. If you still encounter issues after reviewing all of that information then it would be best to provide details about your environment in order for someone to assist. The specific version of OMSA, the browser, and the operating system would be helpful.
http://www.dell.com/openmanagemanuals/
Thanks
OmegaWeapon1988
5 Posts
0
September 28th, 2018 13:00
Yes, it is still happening with Apply and I've gone over the documents.
Server: Dell PowerEdge R610
OS: Windows Server 2012 R2 Standard
OM Version: 9.1.0
Browser: Chrome, Firefox, IE, and Edge
NFLAudio
4 Posts
0
January 24th, 2019 13:00
having the same issue. Windows Server 2012 R2, on Dell R910, running OMSA 9.1.0
netprince
1 Message
0
January 31st, 2019 08:00
I can confirm, having the same results from the web interface.
Also from the command line I get:
Dell EMC OpenManage Systems Management Software (64-Bit) Version 9.2.0
Daniel My
12 Elder
•
6.2K Posts
0
January 31st, 2019 16:00
Hello
Thank you all for the information.
We have reproduced the issue in our lab on an 11th generation server. We are investigating the issue. I will report back when I have more information.
Thanks
Daniel My
12 Elder
•
6.2K Posts
0
February 11th, 2019 17:00
The issue is on the fix list for a future version of OMSA. The destination will need to be set through the iDRAC web interface until OMSA/RACADM is fixed. I think this issue only affects OMSA 9.x and the associated RACADM. If you need to be able to perform this via RACADM or OMSA then I would install OMSA 8.5 until a new version is released that resolves this issue.
zhaojiejie
2 Posts
0
February 11th, 2019 22:00