Unsolved
This post is more than 5 years old
3 Apprentice
•
20.5K Posts
0
30355
How to Install and Run Malwarebytes' Anti-Malware
To download Malwarebytes Anti-Malware go here:
alternate download link 1
alternate download link 2
Save it to your Desktop.
- Make sure you are connected to the Internet.
- Double-click on mbam-setup.exe to install the application.
- When the installation begins, follow the prompts and do not make any changes to default settings.
- When installation has finished, make sure you leave both of these checked:
- Update Malwarebytes' Anti-Malware
- Launch Malwarebytes' Anti-Malware
- Then click Finish.
MBAM will automatically start and you will be asked to update the program before performing a scan.
- If an update is found, the program will automatically update itself.
- Press the OK button to close that box and continue.
- If you encounter any problems while downloading the updates,
and just double-click on mbam-rules.exe to install.
Alternatively, you can update through MBAM's interface from a clean computer,
copy the definitions (rules.ref) located in
C:\Documents and Settings\All Users\Application Data\Malwarebytes\Malwarebytes'
Anti-Malware from that system to a usb stick or CD and then copy it to the infected machine.
On the Scanner tab:
- Make sure the "Perform Quick Scan" option is selected.
- Then click on the Scan button.
- If asked to select the drives to scan, leave all the drives selected and click on the Start Scan button.
- The scan will begin and "Scan in progress" will show at the top.
- When the scan is finished, a message box will say "The scan completed successfully.
- Click OK to close the message box and continue with the removal process.
Back at the main Scanner screen:
- Click on the Show Results button to see a list of any malware that was found.
- Make sure that everything is checked, and click Remove Selected.
- When removal is completed, a log report will open in Notepad.
- The log is automatically saved and can be viewed by clicking the Logs tab in MBAM.
Note:-- If MBAM encounters a file that is difficult to remove,
you may be asked to reboot your computer so it can proceed with the disinfection process.
Regardless if prompted to restart the computer or not, please do so immediately.
Failure to reboot normally (not into safe mode) will prevent MBAM from removing all the malware.
-- MBAM may make changes to your registry as part of its disinfection routine.
If you're using other security programs that detect registry changes (like Spybot's Teatimer),
they may interfere with the fix or alert you after scanning with MBAM.
Please disable such programs until disinfection is complete or permit them to allow the changes.
Text instructions courtesy of quietman7 at SpywareHammer.
Video: