Hi everyone,

I have ran into issue on BIN file load for DMX800 and script halted in middle. Please need your help !!.

This one is a basic DMX800 with following hardware:

*. Two directors, in slot1 and slot 16

*. Qty 2 FEBE boards.

*. Qty 2 MEM boards.

*. Qty 2 DAE's with 7 HDD's in each shelf.

During the bin load the script is failing at step 2D of 8E with error "Please check physical connectivity between DA's and DAE's."  Screenshots attached.!

LED status on DAE as follows:

The First DAE has katana's ID `0` noticed in LCC A and B.

The Second DAE has Katana ID `2` noticed in LCC A and B . So hoping the cabling procedure is correct. I followed procedure on connecvity guide on dmx800.

FIBE ports A and B were used to connect the copper cables. (A0, B0) in DIR 1 and DIR 16.

The symmwin error screenshot also attached.

Looking forward for your assistance to know why the script halting and due to what reason.?.

Please advise. Thanks much.