I am not sure if you can choose the varience yourself.

Just fire

symconfigure -sid XXX -cmd "start balancing on pool= type=thin;" commit –nop

Even after this, you might see some varience.  Read Primus Id emc242014

You might wan't to avoid Rebalancing in production hours.

and 10% variance that I have written about is actually the variance caused by the microcode when writing to the Pool.This variation is caused by the ability of the microcode to skip extent allocation on the next data dev in the pool. If that device's DA is busy that DA can pass on the allocation request to the DA that owns the next data dev in the pool so extent allocation does not have a large effect on host I/O and this causes variance.

and this 10% variance can be balanced by rebalancing process.

regards,

Saurabh Rohilla

HI Deepak,

I am the author of this primus . Rebalance variance can be changed from 1 to 50% using

symconfigure command

set pool PoolName,
type = ,
[, rebalance_variance = ]
[, max_dev_per_rebalance_scan = ]>;

Well as far as the recommended value is concerned, we recommend whateve the default is (its 1%) but the bigger question is does it rebalance the pool to 1% variance? It depends..

regards,

Saurabh Rohilla

Hey Saurabh

Sorry for replying so late.The E-mail Id I am registered with on ECN doesn't work now so no notification. Switched jobs

I understand what you said. So for a senario mentioned below, if am am adding 50 more Data Devs, and wan't to keep varience to default 1%. then would I need to change "Max devs per rebalance scan" from 256 to the new count of data devs i.e 472+50=522 ? What effect will changing this number make?

-bash-3.00$ symcfg -sid xxxx show -thin -pool r5_fc15k_gp4 -detail|more

Symmetrix ID: xxxxxxxxxx

Symmetrix ID                  : xxxxxxxxxxxxx

Pool Name                     : r5_fc15k_gp4
Pool Type                     : Thin
Dev Emulation                 : FBA
Dev Configuration             : RAID-5(3+1)
Pool State                    : Enabled
# of Devices in Pool          : 472
# of Enabled Devices in Pool  : 472
Max. Subscription Percent     : 100
Rebalance Variance            :   1%
Max devs per rebalance scan   : 256

Regards

DpK

HI Deepak,

I have not seen anyone changing the max dev per rebalance scan and there are no document that talks about increasing it. So i cant be sure. May be someone else can shed some light on it.

regards,

Saurabh

i have never noticed increased response times, i still prefer to do it during off business hours.

Is there any performance issue during pool rebalacning ? is this something we need to perform during maintenance window ?