Hi

I setup a remote mode (SYMAPI thin client) on a server to run the Symcli commands. I set following environment variables to run the SYMCLI Commands

SYMCLI_CONNECT_TYPE=REMOTE:

SYMCLI_CONNECT=SERVER1

While executing Symaccess command on the Solution Enabler(7.5) server I get all the Lun mapping data. But when I run the same command on the remote server , I get only the partial data compared the output I got from the main server(Solution Enabler server).

So I have to do anything(any setup I have to make) on the remote server(SYMAPI thin client server) to get the full Lun mapping data.

Thanks

Naren