Issues with Inititators

Yes sorry dynamox, correct the ESX Servers, so i am using the WWN's from the vmhba1 and vmhba2

Sorry about that little bit of confusion

See attached.... hope this helps

can you post screen shot from Connectivity Status/Initiator screen (scramble host names)

and VNX ports plug-in directly to that Brocade ?

nothing changed to my knowledge from the HBA's... cabling stayed the same... We arent using a FC switch, just the Brocade on the IBM Blade side. It shows the port is up and active when I log into the brocade.

Logged-in column has "No", did anything change in terms of HBAs, cabling ? Is it direct connect or you are going through another FC switch ?

you assigned IP to the virtual machine - what do you mean by that, are you connecting ESX servers, Hyper-V servers ?

VNX ports show up Online on the switch ?

switchshow

cfgshow on the switch

Management server - in your web browser enter http://SPA_IP/setup

Did both VNX fc ports and esx vmhba wwns are logged into switch ??  just to reconfirm do nodefind  on those hba wwns

nodefind xx:xx   , if they come up fine then bounce the zone ( delete from active zoneset , wait for min , add it back and activate it on brocade ).

i have a vnx5300... if that makes sense VG2/8 NAS head not sure what that means Sorry

cable the right port, although you said cabling did not change.

Actually, looking even closer you have B2 associated with the data movers which is showing logged in and registered.  So I assume you have a VG2/8 NAS head? 

If this is the case, so don't necessarily replace SPB2 which is associated with the data movers, it appears you simply don't have SPB0 logging in.

Or you could reregister the host.  Might not be a bad idea to free up the MirrorView port; however, the easiest thing would be to recable it the way it was originally.  Comparing Connectivity Status with the Switch output suggests that cables were swapped (unless someone else sees something differently). 

no configurations in effect for defined or effective