VNX 5500 Hard Specs

Question

Hey,

I have a VNX 5500 which includes DPE, DAE for 2.5" disk and DAE for 3.5" Disk, 2 x CS, and a DataMover. I need full hardware specs for all the chassis. I am also looking for all the possible license software/modules available for the VNX 5500. Please send any links to documentation or websites that can provide this information. As I have to fill out a spread sheet with the following information found below.

I dont know if this will help but this is the current versions of the file and block OE

Current Versions:

File: 7.1.56-5

Block: 05.32.000.5.015

Table … CFSAN VNX Software

*Software*	*Version*

Table … VNX Licenses

*Software*	*License Details*
Clustering	Included in purchase

Table …VNX Hardware

*System*	*Platform / OS*	*CPU Type / Speed*	*RAM*	*Hard Drive*	*DVD / CDW*	*Voltage*	*Pwr Conn*	*Watts*	*BTU*	*Install Space / Location*

Thank you,

etaljic81 · Answer

Spec sheet: https://www.emc.com/collateral/software/specification-sheet/h12014-vnx5100-5300-5500-5700-7500-ss.pdfAlso, see attached images

Anonymous User · Answer

Hi,

You may also refer to the below mentioned links:

http://www.emc.com/collateral/software/specification-sheet/h8514-vnx-series-ss.pdf

http://www.emc.com/collateral/hardware/specification-sheet/h8919-vnx5500-f-unified-stor-ss.pdf

Regards,

Suman Pinnamaneni

chjatwork · Answer

How do I find out what software I have enabled if i can not get a hold of my EMC rep?  Is there a command I can type at the CLI to find out or a path I can take on the Unisphere UI? Thank you

etaljic81 · Answer

All-flash vnx

etaljic81 · Answer

In Unisphere, click on System. On the right-hand side click on System Properties and select the Software tab

chjatwork · Answer

But I don't see info about the CS hardware and the datamover hardware properties?

chjatwork · Answer

I am not sure what the VNX 5500-f is, but I figure its not the same as the VNX 5500?

chjatwork · Answer

Ernes, I am guessing the DM and the CS dont have a processor?  I thought at least the DM has a processor?  Thank you,

etaljic81 · Answer

You first link is not for VNX5500. Your second link is for the VNX5500-F array.

chjatwork · Answer

I actually found the answer to this: Click on 'System' on the top menu, Click on 'System Properties' on the right side menu under System Management.

etaljic81 · Answer

See page 10 of the link I sent

etaljic81 · Answer

See page 11: https://www.emc.com/collateral/hardware/white-papers/h8217-introduction-vnx-wp.pdf

dynamox · Answer

CS is a generic 1U pizza box (intel probably), you can use any standard Linux commands to look up CPU/Memory info

chjatwork · Answer

Any idea for the Data Mover?

chjatwork · Answer

Dynamox, your the man!  /proc/cpuinfo worked... Now I need the info for the Data Mover.  I am going to look at page 11 like Ernes suggested. thank you,

VNX

VNX 5500 Hard Specs

Was this post helpful?