VxRail initial config validation error 'Failed creating network to test'

Question

I am able to use my old json file for VxRail configuration. after all step of validation is finished, now I am getting this error.  can anyone has step for this issue ? see below screenshot.

GSFC · Accepted Answer

thanks everyone for looking at my post, I resolve issue by reloading json file and make sure all my required VLAN are preconfigured.

DELL-Naoyuki K · Answer

Checking VLAN error during validation is so common. You should check SW config for VLAN on port which VxRail NICs are connected to.

GSFC · Answer

checked it, all are VLAN are there in switch settings.

VxRail

Was this post helpful?