Solved!
Go to SolutionReplication and IP change
We have a replication setup between two NS20 devices which is working fine. Now due to Data center migration, we will be moving the remote NS20 device to a different location and as a result I need to change the IP addresses (control station, data mover, CIFS server). Now what will happen to the replicated data on the remote device? Can I continue the replication just by changing the IP addresses?
Hi Avilt,
After the Celerra was relocated and a new IP address was assigned to the control station, was a trust recreated between the control stations? This can be under the "Celerra Network Server" tab for BOTH control stations. It can also be created by running nas_cel on each control node:
nas_cel -create -ip -passphrase
Run that on both Celerras, so they can both see each other.
Then you should be able to edit/recreate the data mover interconnect. Note that without the trust, you can't really create/edit the interconnect, because the celerras aren't talking to each other. Also be aware, that the interconnect needs to be created on both Celerras, but i believe the GUI does that for you (i can't remember). Just be sure to double check that, and ensure you validate your interconnect.
Rainer_EMC
6 Operator
•
8645 Posts
1924
0
Posted September 20th, 2011 02:00
If you have the necessary DART level I would (just to be safe) also create synced checkpoint (Replicator Incremental Attach).
This way even if you have to delete the replication for some reason you don’t have to do a full transfer
Rainer
I am still at the planning stage. Currently the 2 devices are in production and I will be moving the DR office NS20 device to a new location. After the move as a first step I will change the control station/SPA/SPB IP addresses. Then how should I proceed? Should I delete the existing trust and DMI on both devices? Appreciate some detailed steps.
Rainer_EMC
6 Operator
•
8645 Posts
1924
0
Posted September 20th, 2011 05:00
I would start with the actual „Using Replicator on VNX manual“ – its got steps for changing addresses
If you don’t know Replicator that well then reading it completely certainly helps
Thank You, understood.
So after creating the trust will I be able to change the DMI properties? I am worried about losing the existing replicated data. How can I make sure after changing the IP addresses, it continues with the replication rather than starting from the scratch?
bcouhbor
59 Posts
1924
0
Posted September 20th, 2011 22:00
Hi Avilt,
From what i understand, as long as you don't delete the replication job, you won't lose the checkpoints used to perform the replication. A high level workflow for the move in my opinion would be something like this:
1. Stop the replication on both the source and destination, prior to shutdown (this would be critical. You wouldn't want to shutdown in the middle of a replication)
2. Shutdown
3. Relocate, and change IP address of Control Station
4. Log into control station and Change IP addresses of interfaces on DataMover
5. Re-estable trust either by using nas_cel or the the Gui, under Celerra Network Servers
6. Edit the DataMover Interconnect to use the correct ip addresses
7. Validate the DataMover Interconnect
8. Start the replication
If i were you, i'd open a support call with EMC, and ask them to validate those steps before you put them into concrete as an action plan.