Hi Sarath,

I think you have enter more informations after -h.

You need IP or hostname.

Try this :

/opt/Navisphere/bin/naviseccli -h 192.168.13.10 register

Regards

Pascal

Hi Pascal,

Thankyou for your quick reply

I tried  /opt/Navisphere/bin/naviseccli -h 192.168.13.10 register

but its the same error message but i guess the ip is my SPA ip address and i am trying to register my machine stemple

but anyway its the the same error shooting up.

thanks & regards,

sarath

Using 'naviseccli -h w.x.y.z port -list -hba' will filter out some unneeded information and will just display the logged in host HBAs.

A bit of a correction to my last post. The Primus doesn't have the latest syntax for the storagegroup command. You'll need to check the syntax in the CLI guide. Within the storagegroup command is a -sethost switch to pay attention to.

On Powerlink follow this path to the CLI guide area: Home > Support > Technical  Documentation and Advisories > Software ~ J-O ~  Documentation > Navisphere  Management Suite > Maintenance/Administration

If you look in the output that the error give you when you run the register command, it is saying that command is not valid. I just checked the latest CLI guide and the register command in not in there, so I think this command is not around anymore. There is a server -register command, but this is used for virtual center/ ESX servers.

EMC Knowledgebase solution emc228087 has an example on how to register a host with the array.

As AranH mentioned, you can use the port -list to see what is logged into the CLARiiON once you have the zoning in place. You need the WWN info in here to register the host via the storagegroup command. This is where you can register a WWN with the right host name and failover mode and in what storage group. The Primus solution talks about this.

A quick question...

Is there any reason that you are not using the Navisphere Server Utility?

It does provide functionality for registering the server with an array.

This software is available on powerlink for all platforms.

Home > Support > Software Downloads and Licensing > Downloads J-O > Navisphere Server Software

J

Hi Jim,

i am actually trying to write a script for automatic configuration of the storage so iam trying to get on to the CLI

thanks

sarath

hi all,

thankyou for your valuable information and support, I think iam am going in the correct path with your solutions. I would test it and get back to you.

Thanks & Regards

sarath

Hi All,

I am able to register the server and its working fine.

Thankyou all once again for your help

Best Regards

Sarath