Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
Solved!
Go to SolutionP
Pasta_Fazole
1 Rookie
•
33 Posts
0
4082
September 14th, 2010 10:00
DAEs Shuffled
I have a Clariion with some of it's own dae's missing and several dae's added from a second Clariion.
My Clariion now has four drawers. My goal is to clear all of the faults, luns, and RAID Groups, then set up new RAID Groups, etc for my development systems.
Any suggestions would be most welcome.
The luns were not unbound and raid groups were not destroyed before the DAEs were removed.
My Clariion has the following faults:
Bus 0 Enclsure 1:Faulted
Bus 0 Enclsure 1Disk0-14:Removed
Bus 0 Enclsure 2:Faulted
Bus 0 Enclsure 2Disk0-9:Removed
Bus 0 Enclsure 4:Missing
Bus 0 Enclsure 5:Missing
Bus 0 Enclsure 6:Missing
Calling EMC Support is not an option. Support has expired and I am hoping to use this storage system for development.
I have consulted the following thread, none of the suggestions has resolved my problems. All attempts at unbinding luns result in the message: "Being used by a feature of the storage system"
Pasta_Fazole
1 Rookie
•
33 Posts
940
0
Posted September 14th, 2010 10:00
After going into engineering mode I attempted to blow away the meta luns (all of my storage groups are already gone) but I keep getting the error "Being used by a feature of the storage system"
So no luck
alias23122
139 Posts
940
0
Posted September 14th, 2010 10:00
Have you checked to see if there are any reserved LUN pools for spanview? Maybe that is holding it back.
Pasta_Fazole
1 Rookie
•
33 Posts
941
0
Posted September 14th, 2010 10:00
There are private luns listed, but no luns in storage groups. All attempts to unbind luns result in the error "Being used by a feature of the storage system"
Pasta_Fazole
1 Rookie
•
33 Posts
672
0
Posted September 14th, 2010 10:00
There are no snapview sessions listed.
Pasta_Fazole
1 Rookie
•
33 Posts
672
0
Posted September 14th, 2010 10:00
cx3-20f
3.24.20.5.016
Pasta_Fazole
1 Rookie
•
33 Posts
848
0
Posted September 14th, 2010 11:00
I tried this on four of my private luns:
navicli -h <SP_IP_address> chglun -(Please contact Support) -l 12 -makepublic
I did not get any errors in navicli, but when I went to
naviseccli -h <SP_IP_address> metalun -destroy -metalun 12
I got the same error "Being used by a feature of the storage system.
Message was edited by: kelleg
kenn2347
4 Apprentice
•
542 Posts
1714
0
Posted September 14th, 2010 13:00
Like i siad before, this should only be done by support/Partner engineers. You can google search for the steps but unless your a partner, you wont have access to FLARE ndu, Recovery and utility partitions that will be needed as part of the proceedure.
Sorry