UNSOLVED
I
Irfanfadzil
4 Posts
0
3194
December 28th, 2017 19:00
Dell SCv2020 Replication
I have deployed:
- 2 units of SCv2020
- 3 units of R430
And the requirement is to do SCv2020 to Scv2020 Replication. I have deployed everything in place and the only thing left is replication exercise. I have followed all the pre-requisites but still, unable to get replication menu to appear. I have study the administration guide for replication setup and follow the requirement listed below:
1. Storage Center Version - 2016 R3.11 Version
2. Storage Center License - Asynchronous Replication (Unlimited)
3. Storage Manager Configuration
4. Storage Manager Communication - iscsI connection
5. Qos Definition
All the requirement above had been follow
DELL-Sam L
Community Manager
•
8058 Posts
•
34386 Points
2331
0
Posted October 1st, 2018 09:00
Hello Hossam,
I am not aware of any other way to replicate form primary site to DR site other than to use SCOS to do so. I am also not sure of any third-party software that can do the replication.
Please let us know if you have any other questions.
CompellentSanUser
8 Posts
2948
0
Posted January 13th, 2018 12:00
The source and destination Storage Centers must be licensed for Data Instant Replay, and Asynchronous Replications. Verify you have all licenses applied on both Storage Centers. If you have then call in to support for help.
hossamsamir2016
1 Message
2363
0
Posted September 30th, 2018 08:00
Dear All
are there any other way to replicate two sites rather than mentioned license ?
are there any third parity SW can do Lun Replication ?
thanks
Hossam
DELL-Sam L
Community Manager
•
8058 Posts
•
34386 Points
2882
0
Posted January 24th, 2018 09:00
Hello Irfanfadzil,
As CompellentSanUser stated do you have the License installed on both SC2020? Also can you access the remote storage center from your Primary storage center?
Please let us know if you have any other questions.