Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
UNSOLVED
isi_reformat_node failing
Hello,
I am trying to reformat a node on an Isilon x210s. When I run isi_reformat_node --factory I receive the following error: "Factory reset aborted.
Node contains 2 drives that did not pass MFG drive check
Once situation is remedied, you will need to
run 'isi_reformat_node --factory' again."
Any help getting this node formatted would be greatly appreciated.
Thanks,
G
just_passing_by
1 Message
0
0
Posted January 26th, 2024 09:48
# isi_reformat_node -f -r --nolkg --factory
INFO: Checking Bay 1/da1 SSD Wear
INFO: Bay 1/da1 is ok
INFO: Checking Bay 2/da2 SSD Wear
ERROR: Bay 2/da2 failed SSD Wear check - DO NOT SHIP [value="13", thresh="10", direction="up"]
isi_radish -a /dev/da[1,2] | grep 'Percentage Used Endurance Indicator'
Percentage Used Endurance Indicator : 9 (0x9)
Percentage Used Endurance Indicator : 13 (0xd)But why there is limit by 10 (thresh="10")? The values are in percent, why more than 10% will be detected as bad drive?
DELL-Sam L
Community Manager
•
8093 Posts
•
34541 Points
0
0
Posted January 26th, 2024 18:17
Hello just_passing_by,
When testing we found that 10 was the best.
DELL-Sam L
Community Manager
•
8093 Posts
•
34541 Points
573
0
Posted January 13th, 2022 10:00
Hello gBIGcan,
You need to make sure that all drives are healthy before reformatting the node. Also, you need to make sure that all drives are supported drives for your system.