Hello all! I bought three Latitude E6420 laptops at a thrift store, and all had little 128 gig SSDs. I tried swapping in a 500 gig WD standard SATA hard drive, but the machines won't seem to recognize any hard drives but the original ones. I've tried every option I can find in the BIOS, including resetting to factory defaults. When I boot up, the laptop doesn't know it has a hard drive at all. I've confirmed that the HD is okay. Is this a compatibility issue? Could some kind of security setting be causing this? Any advice is much appreciated!
These systems were designed for 9.5 mm drives -- newer hard drives are usually 7 mm or slimmer. I suspect you're seeing the result of the drive not connecting to the system board.
Thank you for sharing the details. As per your product details, we see that you are a Federal customer. Unfortunately, due to Federal contractual requirements Social team will be unable to assist you. Please contact the Federal Support team on 1-800-822-8965.
Go into your BIOS and set "SATA Operation" to AHCI.
Does the systems see the HDD now???
Best regards,
U2
NOTE:
Unless you are installing the HDD with the laptop upside down a spacer is unnecessary.
Unfortunately, due to Federal contractual requirements Social team will be unable to assist you. Please contact the Federal Support team on 1-800-822-8965.
My hard drive was working fine before the time stopped keeping time. I needed to replace the CMOS battery. I checked all the BIOS settings before installing the battery and seemed to replace the battery without any issues. Imagine my surprise when the HDD was not recognized.
Without going into all the other solutions that didn't work, the problem turned out to be that the pins on the HDD were not making contact with the pins to the motherboard. When I put the Latitude 6420 back together, i did not tightened the screws that held the HDD in place tight enough.
Basically, I tightened the 4 screws that hold the HDD very tight; started the computer and everything was working normally. Hope this helps.
ejn63
12 Elder
•
31446 Posts
•
155065 Points
1659
0
Posted June 21st, 2021 13:00
These systems were designed for 9.5 mm drives -- newer hard drives are usually 7 mm or slimmer. I suspect you're seeing the result of the drive not connecting to the system board.
You may need a drive spacer (example below).
https://www.cdw.com/product/edge-7mm-to-9.5mm-ssd-spacer-adapter-for-2.5-drives-notebook-hard-drive/3817225