It is just following templates.

Please override the defualt with the label of your choice.

hi i agree with you that it should follow the template. when i look at my tremplate it shows it as follows.

to give you an idea of what happens i have run a test.

I created these 3 devices.

so now i go to label my device.

I then get this screen.if i change it to 002.

and then.

'In use' has two meanings:

  - The media could be in use

  - If you run the task too early after creating the device, you may also see the issue. Just retry a little bit later.

Do you work with 'Auto Media Management' (AMM) at all?

If so, you give full control to NetWorker.

If you want to override AMM and control a device manually, you must disable AMM first.

I have disabled AMM

From what I see in screenshot you provided, you didn't select 3rd device, but rather first one.

Hi Hrvoje

That is my point I when i try an create a new device it defaults to the volume name of the first device.

If i look in my templates it shows the next device number to be zftest.002 but does not number it as such and tries to rename the volume name of the first device.

Whenever you label a media, the very first step of a backup program is that it verifies whether the media already contains a valid label. And the default behavior is to reuse/recycle it.

The label template is just used for the case that NW would just need to label a new media.

Hi

This is where i get confused.

I am creating a new device using the wizard. i then select the device pool i want it to be in. my expectation is that it would then create a new volume name associated with the new device.

How do i create a ne device with a new volume name then.?

To my knowledge, wizard will offer also steps of labeling so I do not understand why do you label it if you used wizard? Anyway, using wizard, create new device (make sure unsuccessful references of previous attempts are gone - device and volume wise) and create new one.  You may wish to create screenshot for each step in case you hit trouble and wish to share your path here.  Another thing is that you may wish to check with your support to do it with you over webex and then you can see it how it is done and what exactly is done different from what you did - it might be a bit faster resolution wise.