UNSOLVED
Poweredge R920 boot problems
Hi,
My build is very unusual. I brought only the Systemboard without chassis. Systemboard is brandnew and has never booted before.
I'm using Systemboard (V7HD0), 2x CPU E7-4880v2, 2x Dell Heatsink, 2x PSU (1100W), 2x Memory Riser (2x8Gb 1600ecc), 2x Fan 120mm,
My problem is at boot up is...
At first on display appears "Configuring Memory..." after one minute appears "...Done"
Screen gets black and the PSU fans stop rotating. VGA-signal gets lost with no error message.
Only LEDs on board keeps blinking.
So I can't enter bios or iDrac.
In my build PCIe card in Slot1 is missing. Usually in Slot1 is NDC-Riser card.
Could this my problem?
I've no heating problems for sure.
Any help is appreciated
regards Rhonon
DELL-Chris H
7 Practitioner
•
9682 Posts
•
48046 Points
612
0
Posted June 11th, 2021 08:00
MountaiNN,
Would you confirm the hardware installed and any errors presented?
Also I would start with taking the R920 to its Mimimum to Post configuration, which is removing everything from the server but the following;- One Power Supply
- One Power Supply Distribution Baord
- One System Board
- One Processor (CPU) in socket CPU1 (minimum for troubleshooting)
- One Memory Riser
- One Memory Module (DIMM)
- One Network Daughter Card
After that then try powering up, if the server completes post then individually add the removed devices back until the issue reapears, which identifies the device causing the issue.
Let me know what you see.
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!- SpoilerNevermind i got it. I didn't think about jumpers at all, it turns out that the jumpers were misplaced. Once set up correctly, everything works as it should.Nevermind i got it. I didn't think about jumpers at all, it turns out that the jumpers were misplaced. Once set up correctly, everything works as it should.
@Rhonon If you still have this problem and this server (probably not) you can try it ;).
MountaiNN
1 Rookie
•
33 Posts
618
0
Posted June 11th, 2021 07:00
I have that same problem, but it seems from 2018 no one even answer..