UNSOLVED
N
new_network_use
2 Posts
0
30474
October 17th, 2005 06:00
3000cn network setup problem
I need some advice for my new 3000cn setup for the network.
The printer is tried to networking for 2 computers (both are in window 2000). I followed the instruction for the installation, using the attached CD to set up as local installation for computer 1. This way, I can use the printer for computer 2 if Computer 1 is on.
Then I tried to install by using the Remote Installation. It asks me for the Administration user name and password which I do not have both of the computers.
Do I have to add the admin user name and password in order to setup, or if there is another way to setup the printer for network.
Appreciate your advice.
new_network_use
2 Posts
326
0
Posted October 18th, 2005 04:00
Thank you for the hint.
After looking in to my router information, it is used as DHCP server. Can you show me how toI change to a static IP, instead.
Thanks lot.
- You would set the static address on the printer. A likely value is 192.168.2.2. This may or may not correspond to an address in your routers static address field (check your documentation, the address given was for an SMC router I had used). It is possible that the router may not have a static range, but it should be possible to reserve this address at the router, so it is not in the DHCP range, and will remain constant.
songioan23
1 Message
326
0
Posted October 27th, 2005 01:00
You set up a static IP through the menu on the printer itself. I am currently setting it up; however it didn't work. I think you can set up it up though the installation software. I don't have the installtion CD. Does anyone know where I can down load the CD. I found only the printer drivers on Dell website.
eqmaven
70 Posts
326
0
Posted October 17th, 2005 15:00