Help

Announcement Banner
Start a discussion

AdamInDC

updated

18 years ago

Solved!

Go to Solution
A

AdamInDC

2 Posts

0

628

June 12th, 2008 09:00

Autostart Version 5.1.2 - Legato Mirroring for windows

Hi,

I am trying to set up a data source for using the Legato Mirroring for Windows config. When I select my source node the source drive section says . Additionally, there is nothing in my target drop downs. Any ideas on what could be causing this issue?

Thank you for your help!
  • T

    tribicic

    157 Posts

    305

    0

    Posted June 13th, 2008 00:00

    As Y said check that the nodes are configured for mirroring...additionally check that Legato Transport Service is running on both nodes. There are also some requirements for the volumes to be mirrored, for example they must be basic, not dynamic partitions....this should help you get going.
  • Y

    yito1

    262 Posts

    305

    1

    Posted June 12th, 2008 10:00

    Hi,

    A probable cause
    1) A drive for mirrors is not made beforehand.
    2) Setting of Remote Mirror Host is not done.

    Please watch data source log if it cannot be settled.
    A hint of the solution may be found.

    Yoshinobu Ito
  • A

    AdamInDC

    2 Posts

    305

    0

    Posted June 13th, 2008 06:00

    Thank you, I am in a VM environment and the partition i wanted to mirror was dynamic, I will add another that is basic.

Dell Support Resources

Latest Solutions

View More