UNSOLVED
Bootup stops after Alienware logo
Just received this for Christmas and turned it on. It will show the Alienware logo and F8/F12 prompts. After that the screen goes blank. Start it up again, goes thru logo screen and then a blue screen pops up saying that your pc couldn't start. It comes up with different options like safe modes and disabling options. Choosing any of these options just shuts down the pc. Need help. its an X51 running or attempting to run windows 8.
Dell - Harish M
1301 Posts
167
0
Posted December 25th, 2012 12:00
Hi jsfnts,
Kindly follow the steps given below and revert .
1. Restart the laptop and start tapping the F2 key at the Dell logo for enter the BIOS.
2. Navigate to the “Advanced” menu.
3. Change the SATA operation/selection in BIOS from Intel Smart Response to AHCI.
4. Press F10 to save changes and exit.
5. Reboot the system.
6. Go back into the BIOS by tapping the F2 key and change the SATA operation/selection in BIOS from AHCI to Intel Smart Response.
7. Save changes and exit by pressing the F10 key.
8. Reboot the system and it should boot normally into Windows.