Equallogic ps4000 series discussion

Question

How to get the information about the system, the interface, the group , the pool, management ip address of the active and passive controller, etc ???

Joe S586 · Answer

You should download the CLI guide (located on the support site where the firmware is downloaded - select the version currently installed on your arrays). you can also install the EqualLogic PowerShell cmdlets (located on the HIT download page). a simple example you would telnet/ssh to the array member and issue the show command at the group name prompt. You would have to capture the output in your telnet/ssh program to save the data. -joe

justsanjeev · Answer

what is the command line for the information required above ??

justsanjeev · Answer

another ...if i have two storage in default pool and i create a volume then the volume will be created to both storage array ???

justsanjeev · Answer

Thanks Don, Much appreciated ...there is another thing i am stuck up. grpbbv> pool show Name                 Default Members Volumes Capacity   FreeSpace -------------------- ------- ------- ------- ---------- ---------- default              true    2       12      12.55TB    12.11TB testpool             false   0       0       0MB        0MB i just created a pool testpool, but when i try to add volume its says the testpool size is zero and can't add volume to testpool ? moreover if i need to add a newely created volume to testpool again i get the error. how can i add storage to a pool ??

Joe S586 · Answer

In order to add any volume to a storage pool, there must be at least one array member in the pool.  Look at your output, you do not have any member in the testpool. Regarding volumes spanning multi-members in the same pool, yes, this is expected.  This is part of the the Capaccity Load Balance (CLB). I have attached the most recent tech report on how the three different load balancers work (Network, CLB and APLB). -joe

justsanjeev · Answer

is it possible to edit the group after it has been created??

justsanjeev · Answer

Hi Don, Could you provide me information about the nas configuration ?

justsanjeev · Answer

grpbbv> nas filesystem create nasFS 1GB % Error - Object does not exist why this error is coming ?

somalik · Answer

I have upgraded my ps 6000 from 6.0.11 to 7.1.7. after that when I reset my device I  get following CLI> reset% Error - Object does not exist% Error - Object does not exist Warning: This command resets an array to the factorydefaults (original condition).  The result is theelimination of all group and volume configurationinformation and any volume data residing on the array. It is strongly recommended that you not reset a runningarray. Instead, use the delete member command which movesdata from this array to other arrays and automaticallyresets this array. This member UnknownIP Addresses associated with this member: Please can you explain the above error after reset

Rodrigoecem

Sobre mi

Actividades de Rodrigoecem

Estadísticas de interacción

Estadísticas de miembros