I have a bad feeling about this. Press power button and get only flashing leds on GFX_PUMP FLEXBAY board. Press power supply test button and I can hear its internal protection circuit click. After PSU dead until unplugged.
So I remove all RAM, peripherals, power, and usb connections from MB. PSU test button will power up fans, vents, and internal lights. Same result for PS1 connected to MB. Connect PS2 to MB and only get PSU protection circuit switched. Never any beeps.
Is my MB cooked? Is it worth replacing or should I just upgrade MB, CPU, and GPU. I like the case too much to just junk it.
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before You Begin. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
Prerequisites
1.Remove the left side-panel. See Removing the Left Side-Panel.
2.Open the PCI shroud. See Opening the PCI Shroud.
3.Remove the drive-bay shroud. See Removing the Drive-Bay Shroud.
Removing the Theater-Lighting Batteries
1.Turn the drive-bay shroud over.
2.Open the theater-lighting battery compartment door.
NOTE: Your computer ships with two AA rechargeable batteries.
3.Remove the two batteries from the theater-lighting battery compartment.
sounds more likely just PSU is failing. Test the motherboard with a good PSU and you will see. A dying psu can commonly still turn on fans and led but there is not enough current or voltage to turn on motherboard.
@jcgaede Is the flasing led labeled LED4 CHARGE? It is right near the gfx pump flex you mentioned. I believe that just means you need to replace the two rechargeable AA batteries for the theater case lighting. You can get replacement envelope batteries on amazon. For some reason this prevents booting the pc.
I forgot to mention, this is where you find the batteries that need replacing. Image 1 is where to find the shroud holding the batteries. Batteries are behind the red arrow.
Only thing I can think of is an abnormal draw from the MIO board, which connects to and charges the batteries .. has the PC been sitting unused and unplugged for a long time and then you booted and this happened?
@jcgaede You can test it without spending any money by removing the two batteries and trying to power up. When the batteries are completely dead an the R4 and won't hold a charge it completely prevents a boot, all you get is the flashing led noted above. But you don't need the batteries to boot, it will boot without the batteries. It is odd.
Tried this. Whether these batteries or replacements are in, the PSU protection circuit trips when pressing the PSU test button. Pressing computer power switch just shuts the blinking LEDs off.
These batteries have no impact on observerd behaviors. They may if I get past the initial power problem since they are dead. Are these just regular rechargable AA batteries? They are identical in size and the people at Batteries+ store claim standard AA.
speedstep
11 Legend
•
46969 Posts
1086
0
Posted November 20th, 2020 04:00
https://www.dell.com/support/home/en-us/product-support/product/alienware-aurora-r4/docs
https://downloads.dell.com/manuals/all-products/esuprt_desktop/esuprt_alienware_dsk/alienware-aurora-r4_owner%27s%20manual_en-us.pdf
Theater-Lighting Batteries
(ALX Chassis Only)
Alienware Aurora-R4 Owner's Manual
Prerequisites
Removing the Theater-Lighting Batteries
Replacing the Theater-Lighting Batteries
Postrequisites
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before You Begin. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
Prerequisites
1.Remove the left side-panel. See Removing the Left Side-Panel.
2.Open the PCI shroud. See Opening the PCI Shroud.
3.Remove the drive-bay shroud. See Removing the Drive-Bay Shroud.
Removing the Theater-Lighting Batteries
1.Turn the drive-bay shroud over.
2.Open the theater-lighting battery compartment door.
NOTE: Your computer ships with two AA rechargeable batteries.
3.Remove the two batteries from the theater-lighting battery compartment.
https://www.amazon.com/Energizer-Rechargeable-Pre-Charged-Over-Charge-Protection/dp/B08HJNZSQ7/
power supplies die.
If they didn't they would be soldered to the motherboard.
Try new rechargeable AA batteries then try a new power supply first.
Given the age of the unit the Theatre LED batteries are also bad.