UNSOLVED
Can Avamar back-up from it's 2 different network interface ?
Hi,
I configured eth0 for 10.x.x.x. network and eth1 for 192.x.x.x network. I selected eth0 in dpnnetutil. I installed an avamar client to 192.x.x.x and successfuly activated it. When I started a backup job, saw that server was not listening port 27000 on eth1. Is there any way to use 2 network interfaces without nat configuration ?
Thanks.
JasonBailey
147 Posts
575
0
Posted May 24th, 2010 18:00
Yeah its possible to have Avamar on two different networks but I think you need EMC to assist to make sure its done right. I am fairly sure it needs an RPQ.
JasonBailey
147 Posts
575
0
Posted May 25th, 2010 16:00
You should call EMC Support and ask them.
All I can tell you is that it is possible because I have seen it, usually a different NIC is used for replication
Hi Guys,
i am doing an implentation of avamar 5 in australia. We are putting in 6 nodes and piping out to Networker 7.5.2 for tape out. In my design i want to run a nic from the avamar box over cross over cable to a second nic on the Networker Storage node. thus removing all the traffic from the LAN.
Did or has anyone got this working or have this configured in a production environment? Also does anyone know if extra Nic's can be inserted in to the Avamar Appliance to support this configuration or similar.
Our Lan backbone is only 1gb so i would like to isolate this traffic away from it. Also we will be replicating the Avamar Nodes accross our DC's and tape out is a fabric solution directly attached to the Networker storage node.
Thanks guys.
andreas.scht
2 Intern
•
219 Posts
575
0
Posted April 20th, 2010 06:00
Hi,
we tried this in a proof of concept and we were told that the second nic is only usable by replication.
We tested with 4.1. But I haven`t read anything that this was changed in v5.
SRY.