UNSOLVED

pba72

updated

15 years ago

P

pba72

1 Rookie

•

40 Posts

0

3854

April 10th, 2012 05:00

Initializing Gsan Failed

Hello

Im installing AVE 6.0 and get error "Initializing Gsan Failed" . Does anybody know  about  this error ?

  • Mark_Bellows

    240 Posts

    1350

    0

    Posted April 10th, 2012 06:00

    Pavel,

    What environment did you install AVE in? VMware, Hyper-V?

    Also, any screen shots show progression will help.

    Mark Bellows

  • Bebo2k

    544 Posts

    1350

    1

    Posted April 10th, 2012 14:00

    Hi Pavel,

    In addition to the information requested by Mark, please also check the network connection speed, make sure it is 1 GB and not 100 MB . If it is 100 MB change it to 1 GB and try the installation again.

    Thanks,

    Ahmed Bahaa

  • ionthegeek

    2 Intern

    •

    2049 Posts

    1350

    0

    Posted April 11th, 2012 05:00

    Ahmed Bahaa wrote:

    If it is 100 MB change it to 1 GB and try the installation again.

    It is a violation of the 802.3 Ethernet specification to force a NIC to 1Gb. More importantly, if autonegotiation failed to bring the NIC up to 1Gb, there is likely some underlying reason and forcing the NIC to 1Gb would almost certainly lead to intermittent and frustrating problems later.

    There may have been a transitory issue where the NIC and switch failed to negotiate to the full 1Gb speed. Restarting network services normally resolves this type of issue. Because AVEs are single node servers, this can be done safely at any time but be aware that on multi-node servers, restarting network services with the GSAN running is likely to cause issues.

    If after restarting the network services the NIC is still not at 1Gb, the cable, the switch port or the NIC may be damaged or defective. Support will normally try a different port and cable first. If that doesn't resolve the issue, the NIC is probably the cause.

  • Druehl1

    2 Intern

    •

    223 Posts

    1350

    0

    Posted April 16th, 2012 12:00

    Hi,

    did you run the md5 checksum test? In the past I had some problems with corrupted files for the AVE.

    If this check is ok, have you correctly run ave-part.pl. netconfig and dpnnetutil5 as written in den AVE Installation Guide (attached)?

    1 Attachment

  • ngk1

    3 Posts

    1350

    0

    Posted April 16th, 2012 12:00

    Yes. I did. The md5 check went fine. I have already installed on one VM, and now trying to configure a second one. Idea is to try out replication for a specific domain or client.

  • ngk1

    3 Posts

    1350

    0

    Posted April 16th, 2012 12:00

    Hi

    Am also having similar problem, initializing gsan failed on AVE. Attached is the errot from the web interface

    Regards

    GKgsan_error.png

  • pba72

    1 Rookie

    •

    40 Posts

    1350

    0

    Posted April 16th, 2012 14:00

    In the finish, I load ovf template again and made the configuration step by step. The installation competed without error.Regards Pavel