After a recent reboot of my M1000e chassis and all its components, I now am receiving the following non-critical alert on IOM-B2, which is an M8024:

"A link tuning failure detected on IO module B2".

I am using v. 4.0 on the CMC, but my IO module firmware is very old (3.1.5.7).  I know that one of my first steps should be to upgrade the IO module firmware.  Since I am using this chassis with AIM 3.4.2, I was going to upgrade to the AIM supported firmware on this module, 4.1.0.6. 

However, I will not have a chance to upgrade this firmware before a meeting with a customer early this week.  Is there a way in the interim to simply clear this non-critical alert from my CMC so it does not raise any questions?

Thanks,

Mike