Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
Solved!
Go to SolutionME
magno.eduado
5 Posts
0
1178
April 13th, 2017 15:00
kinds of Static link aggregation
I have set up an static link aggregation with a powerconect2848 and there are 3 kinds of link aggregation avaiable: Layer2, Layer3, Layer2/3. Which differences there are between them? Can someone indicate some documentation about it ?
On the LAG port will traffic several vlans, which is gonna connect as a trunk port through an vmware standard vswitch.
magno.eduado
5 Posts
669
0
Posted April 14th, 2017 08:00
Thanks Josh,
Another question. How many LAGs the powerconnect 2848 support?
In documentation says "up to 8" another page says "up to 4" on purchase sites shows "up to 4".
On web interface configuration I can see up to 8 LAGs avaiable. Is that correct ? Can I configure up to 8?
DELL-Josh Cr
Community Manager
•
9741 Posts
•
44395 Points
669
0
Posted April 14th, 2017 10:00
I think it was 4 and then later changed to 8, which is why the documentation doesn’t all match.
DELL-Josh Cr
Community Manager
•
9741 Posts
•
44395 Points
669
0
Posted April 13th, 2017 18:00
Hi,
– Layer 2 — Enables load balancing based on static and dynamic MAC addresses. – Layer 3 — Enables load balancing based on source and destination IP addresses. – Layer 2-3 — Enables load balancing based on static and dynamic MAC addresses, and source and destination IP addresses.
Page 104 http://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/powerconnect-2848_user%27s%20guide_en-us.pdf