UNSOLVED
L
LOSTforce10
1 Rookie
•
15 Posts
0
6462
June 26th, 2018 08:00
MXL untagged tagged hybird
Let me start of by saying I have read the configuration guide for the MXL. The word hybrid was not in there at all. (i may of found an old guide)
I have a port (internal) te0/2 that will have a physical NIC many virtual servers (NIC) on it. I will tag the physical port inside the CMC with vlan50 and the virtual NICs will be untagged.
interface Vlan 100
ip address 172.21.1.54/24
untagged TenGigabitEthernet 1/1-32,41-43,50-51
untagged TenGigabitEthernet 0/1-32,41-43,50-51 (meaning if data comes across it will be tagged with vlan 100 right)
interface vlan 50
This is where I have the issue. from my understanding I need to have the command "tagged TenGigabitEthernet 0/2" (Is this like the cisco command "switch port trunk allowed vlan 50") to allow traffic tagged with vlan 50 to pass.
When I go under vlan 50 and I type the command #tagged tengigabitethernet 0/4 i recieve the following message % Error: Tagged flag mis-match Te 0/4. See below:
MXL(conf-if-vl-50)#tagged tengigabitethernet 0/2
% Error: Tagged flag mis-match Te 0/2
After researching I need to put port Te0/2 in hybrid mode... see below.
MXL(conf-if-te-0/2)#portmode hybrid
% Error: Port is in Layer-2 mode Te 0/2
I want the port in layer 2. Where am I going wrong?
To recap I need a port to be trunked allowing vlan 50 and native vlan 100.
On a cisco switch this the command to do this
Switch port mode trunk
switch port trunk native vlan 100
switch port trunk allowed vlan 50
Please help
bealdrid2
1 Rookie
•
117 Posts
4782
1
Posted August 2nd, 2018 11:00
I've run into this, and you need to clear the L2 configuration from the port before you put it in hybrid mode. Something like:
followed by
You may have to first make sure the port is not a member of any VLANs other than VLAN 1 before you do that. At that point you should be able to do something like this: