UNSOLVED
PowerEdge 1600SC Boot problem
Hello,
My PowerEdge 1600SC show a "press F1 to continue, F2 to Setup" message and don't boot automatically after installing Windows 2003 R2. I need it to boot automatically as we work remotelly. Any hint about this? It worked perfectly before 2003 R2 was installed. Thank you
Hello Every one,
I have this problem and i need the solution.
dell openmanage server assistant:
A bootable hard disk was not found in your system. you will need to enable the disk BIOS on at least one disk controller. press any key to reboot the system and enable the disk bios using the scsi firmware setup utility.
Hello Every one,
I have this problem and i need the solution.
dell openmanage server assistant:
A bootable hard disk was not found in your system. you will need to enable the disk BIOS on at least one disk controller. press any key to reboot the system and enable the disk bios using the scsi firmware setup utility.
in the first its gave me "press F1 to continue, F2 to Setup" but when i press F1 and the Open manage assistent is in the CD its gave me the messsage up after choosing the time, I try to Enter in CTRl +M but there cannot find any physical or logical drive.it cannot see the Hard disk, but i can see the green light for the two harddisk. Please any one can help me .
at5147
884 Posts
584
0
Posted December 18th, 2010 10:00
Check for any errors during POST and disable any unused devices in the BIOS.