UNSOLVED

sheppie

updated

18 years ago

S

sheppie

1 Rookie

•

108 Posts

0

3259

October 27th, 2008 08:00

Can't connect to centera using centera viewer

We've just had a new Centera Gen 4 LP installed. Unfortunately we are unable to use Centera viewer to connect to it.

On further investigation the Centera access nodes appear to be listening on port 3218 but not 3682 which is used for the management utilities.

There is no firewall in the way so we can't figure out what the problem is. Neither can the engineers who installed it so they have gone away to do more research.

I just wondered if anyone had come across this before?

Thanks,
Sheppie
  • mikehorgan

    47 Posts

    1659

    1

    Posted October 27th, 2008 10:00

    Hello Sheppie -

    Is this new Centera configured for Compliance Edition Plus (CE+)? If so, remote admin (via the access nodes) is disabled and you must physically plug into the internal network for administration.

    In CentraStar 4.0 (which normally would be installed on a new box), it is possible to configure "management" roles on nodes other than the access nodes to provide remote administration, even on a CE+ cluster. This would be in the documentation under "Network Segmentation".

    Best Regards,
    Mike Horgan
  • sheppie

    1 Rookie

    •

    108 Posts

    1659

    0

    Posted October 28th, 2008 07:00

    Thanks Mike,

    We don't have compliance edition. I figured out that none of the nodes had been assigned the management role so they couldn't be remotely managed.

    Pity EMC don't tell the field engineers about this :)

    Sheppie.
  • mkochans

    1 Rookie

    •

    17 Posts

    1659

    0

    Posted August 18th, 2009 06:00

    I have a CE+ subsystem. We have one node configured as storage/management. The Centera Console updates via this node, but I cannot connect using the Centera Viewer.

    Any ideas?
  • holgerjakob_c0722c

    2 Intern

    •

    337 Posts

    1659

    0

    Posted August 19th, 2009 07:00

    Hi Mark

    Creat a profile with just the monitoring capability. This should be able to connect to the management node. This profile can execute show commands in CenteraViewer CLI.

    For logins with a profile that have the right to do changes, you cannot connect to this node. Typically the admin profile has management capabilities and is thus not allowed to connect.

    Hope this helps, Holger
  • holgerjakob_c0722c

    2 Intern

    •

    337 Posts

    1659

    0

    Posted August 19th, 2009 07:00

    Hi Sheppie

    Take a look at the CCRF form that was completed. If none of the nodes have a management role associated then it was to be expeted that only local connections to the internal network will have the possiblity to connect with Centera Viewer.

    Holger
  • EMCDennis

    124 Posts

    1659

    0

    Posted August 20th, 2009 13:00

    For CE+, you need to attach a network cable to a storage node and assign this the management role - You cannot connect to a node that is also an access or replication node along with the management role. It is recommended that you have 2 such nodes defined for redundancy. You will need to ensure that the node you are trying to connect CV from, has network connectivity (subnet access) to these nodes.