UNSOLVED

cdieck

updated

17 years ago

C

cdieck

9 Posts

0

674

November 12th, 2009 08:00

AX4-5SCi Configuration Question/Issue

I've got a new AX4 (Single SP) and have it connected via 1Gbps network to 2 ESX 3.5 servers with both iSCSI A0 and A1. I've got 2 issues:
1. This thing is super slow migrating VMs from 8+ old servers running Openfiler over iSCSI
2. All the traffic seems to be only going over port A0.

Is there something I'm missing? Is there some way to balance more of the iSCSI traffic across A0 and A1? The iSCSI network running on the same subnet as normal IP traffic, but most of the VMs are shut down and there is little network traffic moving on that subnet.

Any ideas would be greatly appreciated,
Craig Dieck

Message was edited by:
ckdieck
  • Kumar_A

    2 Intern

    •

    727 Posts

    320

    0

    Posted November 18th, 2009 13:00

    See another related discussion at https://community.emc.com/message/363595#363595
  • Kumar_A

    2 Intern

    •

    727 Posts

    320

    1

    Posted November 18th, 2009 14:00

    These are some of the "issues" which I noticed about your configuration:

    1. You are running a single SP version of AX4 - which does not have write cache enabled. This means that for every I/O you will have to access the disk since the write cache is not available in this version of AX4.

    2. As far as balancing I/O between the ports is concerned, you will have to do that manually. ESX server by default will route all the traffic through the lower number HBA port - which happens to be connected to port A0 in your case. Every time you reboot the ESX server, you will need to manually (or through a script) change the behaviour so that all available paths are used for I/O. Note that every time the ESX server will reboot, it will default to directing all I/O through the lowest number HBA port.

  • cdieck

    9 Posts

    320

    0

    Posted November 19th, 2009 04:00

    Thanks Avi.

    I had come to the same conclusion and after talking with the VAR we determined that the unit was not properly spec'd for what we wanted to do.

    We'll be getting the second SP and an SPS and we'll see what that does.