Alignment is something that should be done for EVERY single LUN used by Windows 2003 and below. Even if you don't think it's needed (i.e. low performance requirements), it should be done anyway. You never know when a non critical system becomes critical, so it's ALWAYS better to do it right from the beginning than to have to go back and fix it.
If you have some non-aligned volumes out there and they perform fine, then don't worry about it - just fix it when it's time for a hardware refresh. If you have some stuff that doesn't perform properly, then maybe consider moving the data to an aligned volume.
Alignment does affect all RAID levels - It affects parity volumes more than non parity though. It's still better to do it for all volumes though. You never know when you'll need to migrate that RAID10 LUN to RAID5.
Disk alignment is done usally at the host level and it is for any raid type presetned to that host. If your hosts are W2008, then you dont have to worry about it as it already alignes it properly when you initialize it.
Not sure about your second question but i think it would be just like a host alignment where it is offset only at the beginning. I have never had to set it on the array. Much easier to do it at the host level.
If I recall correctly, you can set the alignment on the CX when the lun is created. The problem with this is that if you migrate the LUN the offset disappears - at least that is how it was explained to me in older flare revs.
1. Is disk alignment only effective for RAID 5 or parity RAID type (RAID 6)?
RAID 1 and RAID 1/0 will not improve performance.
Alignment effects all RAID levels. An understanding or the workload is needed to judge the effect of alignment on performance. There may be no improvement, or a large improvement. It depends.
2. how about offset configuration in CX?
It will only one offset at begining of stripe or will add many offset to many stripes?
The capacity lost to alignment only effects the first stripe.
File system alignment is discussed in several places in EMC CLARiiON Best Practices for Performance and Availability, FLARE Revision 30.0. Particularly, the 'File-system alignment' and 'RAID groups and I/O block size' sections. This document is available on Powerlink. Hopefully this is not the document causing you confusion.
> 1. Is disk alignment only effective for RAID 5 or parity RAID type (RAID 6)?
> RAID 1 and RAID 1/0 will not improve performance.
Alignment WILL improve performance on any LUN, no matter whether it's RAID1, 3, 5 or 10. It has NOTHING to do with RAID levels. Alignment has to do with the master boot record on intel-based operating systems like DOS, Windows, Linux. Modern OSs already align their partition to the right boundery, so you don't have to do it on all OSs anymore.
> 2. how about offset configuration in CX?
> It will only one offset at begining of stripe or will add many offset to many stripes?
Don't use it, because when doing Mirrirview the alignment indeed disappears on the secondary site.
driskollt1
131 Posts
364
0
Posted November 30th, 2010 09:00
Alignment is something that should be done for EVERY single LUN used by Windows 2003 and below. Even if you don't think it's needed (i.e. low performance requirements), it should be done anyway. You never know when a non critical system becomes critical, so it's ALWAYS better to do it right from the beginning than to have to go back and fix it.
If you have some non-aligned volumes out there and they perform fine, then don't worry about it - just fix it when it's time for a hardware refresh. If you have some stuff that doesn't perform properly, then maybe consider moving the data to an aligned volume.
Alignment does affect all RAID levels - It affects parity volumes more than non parity though. It's still better to do it for all volumes though. You never know when you'll need to migrate that RAID10 LUN to RAID5.