UNSOLVED
SC4020 Management network not responding
I've completed the initial configuration for both controllers through terminal/serial as outlined in the SC4020 setup guide. I've triple checked my networking settings and have verified the drops are working.
The net show command on both controllers show eth0 has a state of up and link of down. The duplex is shown as unknown. The link lights on the management ports on the back of both controllers are off.
What am I missing?
If I do a system show the management IP shows as 0.0.0.0. However, each controller has an IP/subnet/gateway/DNS and domain configured on eth0.
Thanks,
Cody
You can't.. I had to call and find someone willing to share it. It's the guide they give to their professional installers. They won't even sell a Compellent array without professional services. They will refuse to process the order. Did you not get a Dell installation tech to come out?
DELL-Daniel Ca
1 Rookie
•
243 Posts
3382
0
Posted July 31st, 2015 13:00
Hey, guys.
I'm glad you got that figured out, cpetry. At the time of this initial posting there was nothing available, true, but since then, we have released this:
http://topics-cdn.dell.com/pdf/dell-compellent-sc4020_Owner's%20Manual_en-us.pdf
Which is an owner's manual that has some guidelines in it. Although, probably not as detailed as the guide someone luckily shared with you, but helpful none the less. :)
Hope that helps, fmonroy
Have a great weekend, gentlemen.
BVienneau
115 Posts
3382
0
Posted November 13th, 2014 08:00
Can you ping the eth0 IP addresses? if so, you should be able to open a browser and http:// to the first controller to start the setup wizard. You won't have a management IP (it's a VIP that moves between the two controllers) until you complete the setup wizard.