UNSOLVED

Zack3g

updated

23 years ago

Z

Zack3g

24 Posts

0

4059

May 15th, 2004 00:00

Inspiron 5100, Mandrake Linux

This is probably a common problem, but searching through the linux board and inspiron board have left me with nothing. Here's whats happening. The onboard speakers refuse to function, but if I plug in external speakers or headphones, I get perfectly functioning sound. There's probably a setting that I am missing somewhere. Anyone have an answer for this? Thanks in advance.
  • dacap

    41 Posts

    189

    0

    Posted May 15th, 2004 01:00

    Zack,

    I am running Mandrake 9.1 on an Inspiron 5100. The internal speakers work fine for me. Which version of Mandrake are you using? How do you have sound configured?

    Since headphones work for you, I presume you already have done these things but I'll mention them just in case

    -- When you configure your kernel, be sure you set it up to use the i810_audio kernel module.

    -- From harddrake, configure the system to use the snd-intel8x0 driver.

    -- You should find the following snippet in the output of the dmesg command:
    i810: Intel ICH4 found at IO 0x1c80 and 0x1400, MEM 0xe0000c00 and 0xe0000800, IRQ 10
    i810: Intel ICH4 mmio at 0xe0b4fc00 and 0xe0b51800
    i810_audio: Primary codec has ID 0
    i810_audio: Audio Controller supports 6 channels.
    i810_audio: Defaulting to base 2 channel mode.
    i810_audio: Resetting connection 0
    i810_audio: Connection 0 with codec id 0
    ac97_codec: AC97 Audio codec, id: 0x8384:0x7650 (Unknown)
    i810_audio: AC'97 codec 0 supports AMAP, total channels = 2

    -- Finally, at the risk of stating the obvious, have you checked your volume control and mixer to make sure your speaker volume is up (as opposed to the master volume or the PCM volume) and that the speaker is not muted?

    DaCAP
  • Zack3g

    24 Posts

    189

    0

    Posted May 16th, 2004 15:00

    Well, I believe that I have done everything that you said to check, but a little more information. This computer has seen every version of linux I can get my hands on, from knoppix live to redhat to slack, gentoo, and now mandrake. I'm flipping through all of them to find the one that best suits the laptop's hardware with as little pain in the rear as possible. I don't have alot of time to spend configuring the thing, I need it to work right out of the box, I suppose you might say. The internal speakers have not worked on any of the above mentioned distros, but the sound card has been auto detected by all of them. dmesg doesn't show any of that which you said it should, so, I would assume that the problem lies in the lack of that. Any help on how to get it to pick up correctly? Would this computer prefer alsa or oss? Oh yeah, the version of mandrake I am using is 9.2 upgraded to 10.0 official, kernel 2.4.22 ... Attempted an upgrade of the kernel, but that caused more problems than it solved. Most everything worked, but after every reboot my TM 1150 wireless card would delete itself, then reboot again, install itself, then reboot again, delete itself..etc So, I went back to what I know works.
  • Zack3g

    24 Posts

    189

    0

    Posted May 16th, 2004 16:00

    Well, after spending a few hours poking through various things, the problem is solved. Not sure what actually did it, but it works now. Thanks for the help.