UNSOLVED

leej1

updated

19 years ago

L

leej1

3 Posts

0

9480

April 21st, 2008 19:00

Installing Processor, Retention Problems

 Hey guys I'm having problems releasing the rentention module clip as displayed here in this image:

http://us.st11.yimg.com/us.st.yimg.com/I/impactcomputersmiami_1997_2090510389

 

The computer i have is a dimension 4600. The problem I'm having is that the manual doesn't really tell me what to do and i sat for about 30minutes trying to get the clip to release with no success or progress.

 

Can anyone explain in detail how to do this correctly so that I can install my new processor?

 

 

  • shesagordie

    12 Elder

    •

    46017 Posts

    167

    0

    Posted April 21st, 2008 19:00

    leej1

    See if this helps.

    Bev.


    ===================================================
    Please don't send me questions about your system by DCF Messenger.
    Post the issue in the appropriate Board, where they will be answered.
  • ty_ger

    812 Posts

    167

    0

    Posted April 21st, 2008 19:00

     

    Refer to my un-impressive graphic.

     

    Pull the red colored portion inwards and downwards.

    This will flex the side colored in blue inwards.

    Then pull the whole clip out towards you.

     

     

    SORRY.. the graphic may not display for about half an hour because I have exceeded my geocities network bandwidth for this hour.

  • leej1

    3 Posts

    167

    0

    Posted April 21st, 2008 21:00

    Yeah I already said I read the online manual and it provided no help Bev.

     

     

    Also ti_ger thank you for the image but I just tried what it explains, the little part gets released at the side when you push it in wards, but how are you supposed to exert a downward push, whilst lifting upwards? If you let go, the thing won't go up and if you keep pushing you can't lift it anyway. There is also very little if any space where you can actually get a grip on the thing apart from that bendy part.

     

    This is a nightmare.

     

    Message Edited by leej1 on 04-21-2008 05:29 PM
  • ty_ger

    812 Posts

    167

    0

    Posted April 22nd, 2008 01:00

    All I can say is that you have to pull inwards and lift up at the same time.  It shouldn't be all that hard to get out... at least on my Dimension 3000 it wasn't too bad.

     

    Maybe a couple of pliers or forceps would make the job easier?

  • leej1

    3 Posts

    167

    0

    Posted April 22nd, 2008 01:00

    please guys I really need help on this so i can fit my new processor :(