
UNSOLVED
Upgrading
Okay, so I have three things I would like to purchase for my XPS 700 at the moment:
Another cd/dvd burner
A gig stick of RAM
Another harddrive
I plan to get stuff from ebay or newegg, and for RAM, I plan to get the same speed.
Question is, which part should I buy first? The optical drive is cheapest.
I need to figure out which size HDD to get.
Thanks in advance!
Another cd/dvd burner
A gig stick of RAM
Another harddrive
I plan to get stuff from ebay or newegg, and for RAM, I plan to get the same speed.
Question is, which part should I buy first? The optical drive is cheapest.
I need to figure out which size HDD to get.
Thanks in advance!
Responses (16)
Solutions (0)
pointguard1122
1891 Posts
508
0
Posted September 20th, 2006 00:00
I would suggest you biy a SATA cd/dvd burner. I have heard adding an IDE drive can slow down the system, especially on boot. I have been looking for one, but they don't seem very cheap. Perhaps I will wait a while. You might want to wait and see on the RAM too. There has been no statement or no reason to think Dell will actually give us a BIOS update that will allow 800 speed Ram, but I am still holding out hope. I have seen quite a few SATA harddrive deals lately though.
griffy208 wrote:
Okay, so I have three things I would like to purchase for my XPS 700 at the moment:
Another cd/dvd burner
A gig stick of RAM
Another harddrive
I plan to get stuff from ebay or newegg, and for RAM, I plan to get the same speed.
Question is, which part should I buy first? The optical drive is cheapest.
I need to figure out which size HDD to get.
Thanks in advance!
pointguard1122
1891 Posts
508
0
Posted September 20th, 2006 01:00
If you got it with the XPS 700, it is SATA. They are the thin plastic cables with a small plug. The same plugs that run from the 6 places on the mobo to the DVD bays and harddrive bays. They also use different power plugs. The XPS is set up for SATA, but does still have a few IDE ribbons.- This is a FAR better SATA dvd/cd burner, the Plextor PX-755SAThis model is even sold in Fry's stores for only $115 or so right now.-David
krdomingue
181 Posts
508
0
Posted September 20th, 2006 03:00
pointguard1122 wrote:
I would suggest you buy a SATA cd/dvd burner. I have heard adding an IDE drive can slow down the system, especially on boot.
The ide optical drive doesn't really effect the speed of your system, but if you have a SATA cable open, then you might as well buy that. The drive is limited to its read/write speed, which for even for the best drives on the market, it is the same for both ide and SATA drives. I would prefer to install a lightscribe dvd burner. I was originally going to replace the dvd drive with a ide lightscribe dvd burner, but then decided that there was no reason to take it out if I already have the slots. I purchased it on sale at best buy for $82 a few weeks ago. Not sure what to do with three optical drives though.You definitely want to make sure any hard drive you add is a SATA drive. I also added a 500 GB hard drive and will add a fourth drive as the need arises.Message Edited by krdomingue on 09-19-2006 11:22 PM
pointguard1122
1891 Posts
147
0
Posted September 20th, 2006 11:00
I personally would wait for the DX10 cards and go with dual Nvidia cards. That will really take advantage of the SLI chipset and future proof your system.
griffy208 wrote:
I think I also want to swap my X1900 XTX out for an X1950 XTX at some point. What do you guys think?

griffy208
288 Posts
508
0
Posted September 20th, 2006 00:00
I hope this isn't a stupid question, but how can I tell if my computer cables are SATA compatible, and if my current cd/dvd drive is SATA?