HabibG2

updated

19 years ago

H

HabibG2

455 Posts

0

971

November 7th, 2007 09:00

A quick question on Clustering

I am bout to embark on my first Cluster backup !!

I understand that I have to install NW clients and appropriate modules on all physical nodes. I believe I also understood most of the configuration side of thing, except;

Do I need to install any NW component on the Virtual node?

Thanks
Habib
  • ble1

    6 Operator

    •

    14354 Posts

    •

    56186 Points

    574

    0

    Posted November 7th, 2007 12:00

    Do I need to install any NW component on the Virtual node?

    No. When backing up virtual node SW gets called from active node. Just follow installation guide and you won't go wrong.
  • dcarlen_jr

    15 Posts

    574

    0

    Posted November 7th, 2007 10:00

    We have done away with our clustering.. yes, you will need 2 cluster client licenses for the physical nodes and a deticated storage node license for the virtual node. thats the way we did it..
  • HabibG2

    455 Posts

    574

    0

    Posted November 8th, 2007 08:00

    OS: W2K3 R2 Server
    NW: 7.3.3 Built 510
    --------------------------

    I have now configured my two Physical Nodes (PNODES) and my Virtual Node (VNODE) as instructed by the doc. Both my (PNODES) are Storage Nodes. I can back up my PNODES but I am having problem with my VNODE.

    In my VNODE client configuration I have made the necessary entry in the Remote Access fields and in the Storage Nodes fields I have entered my two PNODES devices. My directive on the VNODE is set to "ALL".

    When I initiated my backup nothing happened, I enter a waiting mode, the volume is not mounted.

    Also, I have lots of shared folders on my VNODE, but I notice the by specifying ALL I only see the Q drive in the waiting entry and not all my data.

    Where could I be going wrong?

    BTW: I can open another thread if this one is not appropriate.

    Thanks for your help.
    Habib
  • ble1

    6 Operator

    •

    14354 Posts

    •

    56186 Points

    574

    1

    Posted November 8th, 2007 08:00

    Yes, new thread would be fine. Do you see any pending messages? Instead of saveset All for VNODE try to specify disk which is shared.
  • HabibG2

    455 Posts

    574

    0

    Posted November 8th, 2007 08:00

    OS: W2K3 R2 Server
    NW: 7.3.3 Built 510
    --------------------------

    I have now configured my two Physical Nodes (PNODES) and my Virtual Node (VNODE) as instructed by the doc. Both my (PNODES) are Storage Nodes. I can back up my PNODES but I am having problem with my VNODE.

    In my VNODE client configuration I have made the necessary entry in the Remote Access fields and in the Storage Nodes fields I have entered my two PNODES devices. My directive on the VNODE is set to "ALL".

    When I initiated my backup nothing happened, I enter a waiting mode, the volume is not mounted.

    Also, I have lots of shared folders on my VNODE, but I notice the by specifying ALL I only see the Q drive in the waiting entry and not all my data.

    Where could I be going wrong?

    BTW: I can open another thread if this one is not appropriate.

    Thanks for your help.
    Habib