UNSOLVED
Backup Not Starting
Hi,
I am using NetWorker 7.2.2. Till today everything was working fine but now for one client in a group backup is not happenning. It is not showing any error message. I stopped the backup and then put the same client in test group. I run rpcinfo command which shows output correctly. I run "savegrp -pvvv -G test" comamnd which got succeeded. Then I run test group but again the problem is same. It extracted All into individual savesets but after that backup did not started. Its neither is failing nor its running.
Any suggestions.
Hi Crvelin,
I wil check and let you know.
The old version is because of the plan of the managemnet to move the datacentre to new location where new setup will be established. And we do not have support for this site anymore. So for next 3 to 4 months we will use the existing version.
ble1
6 Operator
•
14354 Posts
•
56186 Points
70
0
Posted November 21st, 2009 03:00
tc, tc tc, we have 7.6 released and you are still on 7.2.x?
Anyway, this is most probably routing or some kind of network problem. At least in most of the cases. I had that few weeks ago when vlan tagging addresses on my storage nodes where not right and All had been successfully resolved, but all sessions just kept hanging and never reached storage node. Can you go to the client and run echo print | nsradmin -p 390113 -i - -s
Also, try manual initiated backup from the client.