we've got plenty of old Tapes in our Library that have to be removed and replaced with new LTO4 Tapes. How do I create an exact copy of an tape so i can recycle the old ones? Does a clone of such a tape behave in the same way the original would or is there a different way to get an exact copy of a certain tape?
If you clone it you will get data onto LTO4, but bare in mind that LTO4 will have higher capacity thus you will be able to put 2 or more old volumes onto new LTO4 volume.
but a straight Clone will go 1:1, so be able to populate the new LTO4 media, the cloning will need to be done at the saveset level..
? I can do volume cloning of volume Alto1 to Alto4.. then I do Blto1 which will also use the space on Alto4... or are you suggesting that it will use Blto4?
I tried Volume-Cloning yesterday. Right-Clicking the volume to clone and selected cloning. The following problems occurred: - All savesets on the clone were marked "aborted". - Networker labeled an additional volume to the clone pool. (Save Set cloning?)
Does a volume-cloning automatically become a save-set-cloning when savesets on the volume to clone are not entirely present on a single volume? How can I avoid this?
Is it somehow also possible to get a copy of a tape with the "dd"-command on unix?
Everything in NW is ssid cloning. Volume cloning since 7.4.x or 7.3.x works in way that only ssids on source volume that have head there will be cloned. So, if you have ssid which is tail on that tape, it won't be picked up for example.
You can do copy of tape with dd, but NW won't be aware of that so that's not approach you should be after.
What I do not understand is why all tour ssids on clone were marked as aborted; are you sure something else didn't went wrong there?
I tried cloning a volume again and this time it worked. I realized that all save sets on the volume I direct the cloning to are as long "aborted", as thyre not completely written on that volume. That is why all savesets on my former Cloning were in that state. They just werent finished.
The performance was average. The cloning took about 110 min. for a total amount of 450 GB which is about 60 MB/s (LTO4-Drives and Tapes).
How can I boost the speed of the Cloning? Is cloning handled inbound between the drives or is all data first sent to the cloning storage node?
ble1
6 Operator
•
14354 Posts
•
56186 Points
585
1
Posted October 14th, 2009 06:00