Help

Start a discussion

MSAdmin

updated

15 years ago

Solved!

Go to Solution
M

MSAdmin

7 Posts

0

7377

November 3rd, 2011 11:00

Problem With SNMP Scan

I am trying to run an SNMP scan from my asset management software and it isn't seeing my PowerConnect switches. Most of my switches are 3524's. The scan is using SNMP V1. Is there a setting I am missing to enable the switches to be seen? FYI, I have switch access locked down to HTTPS and SSH if that matters.

  • DV

    DELL-Victor

    98 Posts

    1495

    1

    Posted November 3rd, 2011 14:00

    If you can, eliminate any security, ACLs, Firewall issues that may be between you and them, and make sure your default-gateway is set on each switch.

  • DV

    DELL-Victor

    98 Posts

    1495

    0

    Posted November 3rd, 2011 11:00

    You will need to setup a community on the switches before discoverying them.  The syntax is...

    console(config)#snmp-server community

  • M

    MSAdmin

    7 Posts

    1495

    0

    Posted November 3rd, 2011 12:00

    I setup a community with "public" but it still doesn't see them on the scan. I have it set to:

    String: public

    Management Station: 0.0.0.0 (any)

    Access Mode: Read Only

  • M

    MSAdmin

    7 Posts

    1495

    0

    Posted November 3rd, 2011 14:00

    Found the problem. I had my access profile set to https/ssh only. I had to add snmp to that list.

Dell Support Resources

Latest Solutions

View More