UNSOLVED

hk-IT-Learner

updated

7 years ago

0

882

January 12th, 2020 17:00

Resolved - Networking Help - Trunk Mode or General Mode

Hi,

I am new to networking and trying to config Dell Powerconnect 7024.

I have router running Opnsense and have 3 VLANs setup on it. Before the Dell switch I was using cisco with a trunk port setup as below.

Router  <--- Trunk(VLAN 10,20,30) ---> Cisco Switch <--- Trunk (Allowed VLAN 20,30) ---> Cisco AP

I have configured dell switch same way as cisco switch but network is not stable.

Issue 1 - is that I have 2 SSID setup with 2 different VLANs in AP, out of 2 only 1 is able to connect via AP 2nd SSID does not connect (no internet access or IP). If I create an access port for that same VLAN and plug device directly I get connectivity. 

Issue 2 - after a device reboots (connected directly to switch) it will loose network or wont get an IP.

I believe my setup of trunk ports are incorrect. I also found out that a General Port can be configured which act as hybrid port. 

If someone can guide me what are the core differences and what can i do to improve network stability that will be greatly appreciated.

 

Thank You

 

Best Regards

Homi

 

 

  • DELL-Josh Cr

    Community Manager

    •

    9801 Posts

    •

    45350 Points

    754

    0

    Posted January 13th, 2020 09:00

    Hi,

    A trunk port only carries tagged traffic. A general port carries one untagged VLAN set as a PVID and the rest of the VLANs are tagged.

  • 745

    0

    Posted January 13th, 2020 18:00

    Hi Josh,

    Thanks for your msg.. I resolved it by removing native vlan 1 and adding 30.

    Off this topic.. the switch i bought came with https://dcomcomputers.com/dell-powerconnect-7000-series-sfp-module-0j3pc9/

    I want to use 1 of the SPF+ ( Dell FTLX1371D3BCL-FC) module in NAS in future. Can you please suggest what are some of the dell or other manufacturers 10G network card that are compatible with them?

    Thanks in advance.