Solved!
Go to SolutionPERC3 and PERC4 in same system
I have a PowerEdge 2650 with the PERC3/Di ROMB (RAID on motherboard) option installed.
I installed a PERC4/SC in one of the PCI-X slots so i could have an external interface to hookup a PowerVault 220S to.
The problem is that during boot-up I can see and configure the PERC3/Di, but nowhere do i get the option to access the configuration of the PERC4/SC, or even see anything that tells me that the PERC4 is even installed.
Can't find anything obvious in BIOS setup that would let me activate or de-activate the visibility of the PERC4 in Boot-up.
Am I missing something here?
Thanks in advance,
BeekerC.
veltech
61 Posts
515
0
Posted April 5th, 2011 09:00
BeekerC
You should have no problem running the onboard raid perc3 and the perc4 controller card at the same time. I have a 2650 with that same config running just fine. I would try to reseat the Perc4 card and if it still doesn't show up then I would question if the card is good.
Good Luck!