I noticed when I got the SNC Manager working that the SNC seems to have "Data Mover Module" enabled. Does this mean I can use it with software that supports this (BUEforWIN 9.1) and do serverless backup?
Also there are other options, some not enabled (need a key), do I need any of these.
Finally...there didn't look like a whole bunch of configuration needed to be done with the SNC...it kinda just worked out of the box. The manual just shows the various menus, but, doesn't explain what must be done to make things properly work. Anything I need to specifically do? I'm using only FC1 and SCSI 1&2 at this point.
Many of the options on the SNC are a separate license, but DELL does not offer these upgrades and does not support these features (Data Mover, VPS -virtual private SAN). However, you could pursue this on your own with ADIC and obtain a keycode from them
Serverless backup will work with third party applications that support serverless backup. One such application is CA ARCserve. Backup Exec also supports serverless, but you will need to contact Veritas on their support for the 136T.
Virtual Private SAN (VPS) is only needed if you intend on supporting a heterogenous environment where you Unix and Windows systems sharing the library.
When setting up the SNC, you "may" need to set up the channel zoning and device mapping. You will need to verify if it is mapped correctly. Depending on your SAN topology, you may need on one FC node on the SNC. If your SAN is a single fabric, only one node is needed. Depending on how many drives you have, you can evenly distribute them across the SCSI channels on the SNC. As an example, if you have two drives, you can place the robot on bus 1, drive 1 on bus 2, and drive 2 on bus three. You would than set each SCSI bus to map to FC node 1.
To setup the channel zoning and device mapping, you need to install the SNC bridge manager software (server and client apps) and configure the properties for the SNC.
I didn't think that I needed the other options, but, the datamover does say installed = YES, so, I assume it works, and I would be somewhat interested in that working. I'll talk to Veritas on that, thanks.
On the zoning, I have the two drives hooked to one SCSI and the robot to another, and have them all zoned to the single fiber port, so, sounds good!
dell-richard g
605 Posts
85
0
Posted February 18th, 2004 16:00
Many of the options on the SNC are a separate license, but DELL does not offer these upgrades and does not support these features (Data Mover, VPS -virtual private SAN). However, you could pursue this on your own with ADIC and obtain a keycode from them
Serverless backup will work with third party applications that support serverless backup. One such application is CA ARCserve. Backup Exec also supports serverless, but you will need to contact Veritas on their support for the 136T.
Virtual Private SAN (VPS) is only needed if you intend on supporting a heterogenous environment where you Unix and Windows systems sharing the library.
When setting up the SNC, you "may" need to set up the channel zoning and device mapping. You will need to verify if it is mapped correctly. Depending on your SAN topology, you may need on one FC node on the SNC. If your SAN is a single fabric, only one node is needed. Depending on how many drives you have, you can evenly distribute them across the SCSI channels on the SNC. As an example, if you have two drives, you can place the robot on bus 1, drive 1 on bus 2, and drive 2 on bus three. You would than set each SCSI bus to map to FC node 1.
To setup the channel zoning and device mapping, you need to install the SNC bridge manager software (server and client apps) and configure the properties for the SNC.