My Dell 944 printer suddenly stopped working yesterday. The display stopped working and when I tried to print something I got an error saying that the computer couldn't communicate with the printer. It seems to be getting power since the green light on the on/off button is illuminated but the display is black and none of the buttons do anything. I uninstalled it and attempted to reinstall but I can't get past the first step because it says the printer needs to be connected to the computer via USB cable (which it is). I've unplugged and plugged everything back in, restarted the computer etc and I still get nothing. It's old enough that my warranty has expired so I'm wondering if anyone has had a similar experience. And whether or not I should be shopping for a new printer.
Unplug the printer from the wall. Now remove the power brick from the back of the printer. Wait 60 seconds, then plug everything back in. Power the printer on.
I've tried that a couple of times. I also unplugged from the power strip and plugged directly into the wall. The on button is lit up but pressing it doesn't do anything and still no display.
Unplugging the printer or powering it off doesn't reset the error messages the printer gets. You MUST physically remove the power brick as it keeps the printer charged up for a period of time. Removing the power brick for 60 seconds resets the error messages.
If you still get nothing, open the printer and remove the blac Dell Series 5 ink cartridge. Look for tape and reseat the Black Cartridge. Now do the same for the Dell Series 5 Color cartridge. If the printer is working correctly, it should try to print an alignment page. Any error messages?
You are using Dell Series 5 ink cartridges in the printer, correct?
Sorry, I guess I wasn't very clear. I did remove the power brick for several minutes in addition to unplugging everything else. I also inspected the ink cartridges (which are Dell Series 5 that I just replaced a week ago and worked fine up until yesterday). Still no signs of power other than the on button lighting up - no display or anything. And when I try to install the printer the computer doesn't recognize that it's there. It's almost like the power button isn't functioning and I can't actually turn the printer on or there's a power source issue.
PudgyOne
11 Legend
•
30315 Posts
•
106638 Points
295
0
Posted June 3rd, 2009 15:00
jlr80,
Unplug the printer from the wall. Now remove the power brick from the back of the printer. Wait 60 seconds, then plug everything back in. Power the printer on.
Do you see any display?
Rick