The problem started with I was adding a second hard drive. The first error was setting the jumper to slave on my old HD when it should have been "cable select". I was attempting to make my old, primary hard drive, the "second" HD and the new HD the boot HD. When I attempted to run the utility that would accomplish this (included with the new seagate HD) the system froze.
Since then I have been able to install the new HD and make it the boot drive but I have not be able to ever tet the old HD to work. Symptoms:
1. If I simply try the old HD alone (as the primary HD and with out the second HD in the system) the computer will not even begin the boot process though the HD does spin.
2. If I put the old HD in the "second HD cable location" (the connection nearest the CPR and not at the end of the cable) and the new working HD in the distal (prime HD) location, not only will the system not boot, I cant even boot from the CD as the CD isn't "located"
This is a XP professional system.
Any ideas on how I can get this to work?
Kelly
Message Edited by cobrakelly on 02-19-2004 04:50 PM
MichaelC.
2 Intern
•
406 Posts
326
0
Posted February 20th, 2004 11:00
cobrakelly,
Thanks for using the Dell Community Forum.
Can you tell us what model system this is?