file name VNX_Simulator_8.1.0.15_1DM.zip ?

Just downloaded and extracted using WinRar without issues.

That's weird because I've downloaded it multiple times and it's been "broken" or "corrupt" each time. I've tried the winrar and 7zip....

not sure what to tell you, works fine here.

https://download.emc.com/downloads/DL49031_VNX_File_Simulator_(OE_8.1.0.15)_Single/Dual_Data_Mover_(zip_package).zip

Hi,

Take a look into the zip file. Using windows unzip a file size of 1,33 Pbyte was shown. I didnt have a problem when using winrar or 7zip thou. Might be related..

kr

WinRAR: 5.20 64bit

Hello,

I have downloaded the VNX simulator from this link: https://download.emc.com/downloads/DL49032_VNX_File_Simulator_(OE_8.1.0.15)_Single/Dual_Data_Mover_(OVA_package).ova

and it seems to upload and deploy to vCenter just fine.

What I have problems with is setting Networks mapping for its 3 NICs and actually obtaining a "root" login.

Anybody knows the "root" user login for VNX Storage simulator 8.1.0.15

thanks,

Dan Zilberman@ VMware

Hi,

user: root / nasadmin

pw: nasadmin

kr

Hi folks,

I am experiencing a strange but consistent problem with VNX File system simulator (which I managed to download and install as an OVA) . I follow the VNX configuration guide and set up fixed IP addresses on eth1 and eth2 and after that I am able to access the Unisphere control station via https:// for the first time until I follow steps to run the

# ./configure_nic server_2 -a eth1(different NIC than eth2)

and then

/nas/sbin/setup_clarion –init

It creates LUNs but after a reboot of VNX File server VM I am no longer able to access the Unisphere station: https:// . This is pretty consistent with consequent uploads of same VM.

Is it critical to bind server to a different ETH NIC than ETH2 (which I did) and use fixed IP addresses for these NICs? Any other reason why this may not work - what LOGs should I look at please?

thanks,

Daniel

i use the same interface that is used by the control station (cge0)

Aftter I have removed manually configured VNX configuration settings done earlier:

# ./configure_nic server_2 -a eth1(different NIC than eth2)

and then

/nas/sbin/setup_clarion –init

to initiate LUNs (turns out one Data mover is pre-configured already), the Unisphere runs OK (see attached).

I am just getting a couple of Critical Alarms and DME Data Mover 3 slot is empty.

Should I configure that Data Mover in order to remove those Alerts?

(New to this whole thing, have many questions

thx,

Daniel

i think you need to give your VM more memory so that you can have 2 datamovers. I don't care about the second datamover so i left it alone.