Need urgent help with an existing kit. Customer is using an SC5020 and has recently added a refurb SC420 with few 2.4TB 10K drives(XWF6X). They needed additional capacity and have ordered X7NC4 drives. When inserted an error shows up stating "Disk drive line EnterpriseValue is not compatible with System". We believe both the part no.s are compatible with SC. The customer is moving to Isilon next year and wanted some additional storage urgently.
Dell part# RWR8F is not a compellent drive.The issue that you are having is that the drive doesn’t have compellent firmware on it.That is the reason that you are getting the error of unsupported drive.Compellent drives have a base firmware on them that is excepted for compellent systems.There is not a way for a customer to force flash the base compellent firmware on a drive so that it can be read by the system.You will need to get a true compellent drive that is read by the system.
You can’t reinsert a drive in a compellent system as the serial# of the drive will be marked as bad.The only way to resolve this is to call into support to resolve.
I have the ST2400MM0159 (2.4TB 10K SAS) in my SC420 on my SC5020s.
Some thoughts:
The X7NC4 is a 4K and not 512bytes per Sector Disks so you may need a rescent SCOS Version. My 5020 was a DIP and IIRC i imaged the System with 7.3.x . So if you have something older this may the reason
If you buy some kind of "used" disks the Question is was the Disk erased or are old data on that disks. Do you buy from Dell and only the SC420 is refurbished or does the Disks comes from 3rd. Party?
If you have Support left on the unti you should remove the SC420 and perform an SCOS Upgrade to 7.4.x together with Dell. After that add the 420 again and see if something changed.
We've recieved replacement drives. When Inserted it automatically created a new folder under assigned folder but unable to release or add it to the pool. When removed an re-insterted after changing the default setting to unassigned, the drives just showed up a status of "Down". Would that mean the drive had failed? It shows as SF79 on the drives firmware which seems accurate. The Part no. for the new disk is: X7NC4
Hi, having the same issue with some 1.2TB drives, EnterprisePlus line, which are not recognized by the SC.
Already tried "disk set <disk_index> 120 EnterprisePlus -systemwriteonly". The command doesn't return any errors or warnings, but the drives still remain down. Tried "disk unclobber <index>", with no effects....
Running 7.5.10.12 (I think it's the latest for SC4020).
Has anyone managed to move forward with these errors?
Thank you Charles. Sure, please see below. I've attached a picture with the "good" drive and with the "bad" drive. They are both the same P/N, they run the same firmware FE40.
Also, I've attached "disk get" for both drives (I've deleted some lines so that I get within 10k characters). Setting the DriveLine with disk set didn't work. SCOS didn't update the firmware on the drives.
DELL-Sam L
Community Manager
•
8061 Posts
•
34395 Points
1243
1
Posted December 9th, 2020 09:00
Hello Karan K,
Dell part# RWR8F is not a compellent drive. The issue that you are having is that the drive doesn’t have compellent firmware on it. That is the reason that you are getting the error of unsupported drive. Compellent drives have a base firmware on them that is excepted for compellent systems. There is not a way for a customer to force flash the base compellent firmware on a drive so that it can be read by the system. You will need to get a true compellent drive that is read by the system.