Areeb1988,

I did some digging and we do not have a list of all the different events that will cause an SNMP trap. However what you can do is install the latest MDSM which has the MIB file installed with it. Then you can set up all the SNMP traps without using any kind of 3rd party software.

support.dell.com/.../CLIMR2g.pdf

The SNMP section starts on the bottom of page 56. It is recommended to have the firmware  and MDSM up to the latest version. If you have any questions please feel free to let me know and I would be happy to assist.

Dear,

What i mean that i want a list of the Events ID and its Message Body i order to learn the RSA These Events

Unfortunately we do not have an actual list of all the possible event IDs and the message body that are possible to get on this array. That is why we recommend setting up the SNMP traps to catch all those errors as they come.

Dear,

Is there is any simulator that could simulate the snmp Traps, send traps and i will receive them to get the id and the description.  

The only SNMP info that we have for this array is included in the document listed above.

Dear,

I found some traps description for Dell products (RAC, BMC), the link shown below, is there is any thing like that related to MD3000i SAN.

<ADMIN NOTE: Broken link has been removed from this post by Dell>

Regards

Dear,

the MD3000i SAN Sends just Critical Events, is there any configuration to send any event to snmp?

Regards

Areeb1988,

When you are configuring the SNMP alerts you should have options to send critical, warning, and even informational events.

Dear,

In The MD3000i SNMP Window Configuration there is no any option to select alerting level

Sorry for the conclusion, I looked at a simulator and for the MD3000i it looks like  you setup the community name, the trap destination, and the SNMP addresses and then it just sends everything. It looks like it is an all or nothing setup. When I said there were options on what to send that is on the EQL arrays. I apologize for that.